3" Single Wall Flue Kits

A single wall flue pipe and accessory set designed for use with Little Lenny, Lenny, and Florence. Not compatible with Burt or Betty.

Made from stainless steel for durability, corrosion resistance, and a precise fit. This flue pipe set connects seamlessly with your stove, providing a clean, efficient route for smoke and heat to exit safely.

Includes

Internal Cover Plate
Powder coated black for a durable finish. Features pre-drilled screw holes and includes black screws for easy installation. The plate also has extending holes, allowing for adjustment if your roof has a pitch or angle, ensuring a clean and flexible fit.

Rain Cap
Supplied with nuts and bolts for secure fitting and effective weather protection.

Rubber Silicone Boot
Safe operating temperature up to 200°C, with a maximum short-term limit of 225°C.
A flashing kit should be installed with a minimum distance of 110–120cm from the stove to allow sufficient cooling.
Always wear gloves when installing, as the inner plate edges may be sharp.
For the best seal, cut the silicone opening 20–30% smaller than the pipe diameter.

Important Information

Fittings are not fully watertight. To prevent water ingress, high-heat seals, tapes, or lubricants should be used when fitting.
We do not accept liability for any loss or damage arising from the use of the flashing kit, however caused.