This flue pipe and accessory set will fit Little Burners: Little Lenny, Lenny and Florence. **Not Burt or Betty**
Internal Cover Plate
250mm x 125mm (x2), 80mm hole diamater for flue pipe to sit through. 8 screw holes (4.5 diameter), black screws included.
0.8mm mild steel - powder coated black.
Rain Cap
6x Nuts and bolts included.
Operating temperature - Rubber Silicone Boot
Safe operating 200° degrees - Max 225 ° (Short period of time).
A flashing kit should be installed with a minimum distance of 110-120cm from the stove to allow sufficient cooling.
Always wear gloves when installing the kit. May have sharp edges on the inner plate.
We recommend cutting the product 20-30% smaller than the pipe to ensure a perfectly tight seal
This flue kit sits on the exterior of the flue stub on the burner.
We do not accept any liability for loss or damage incurred by the use of the flashing kit howsoever caused.
Please note that fittings do not provide a watertight fit. High heat seals, tapes, and lubricants should be used when fitting to prevent water from entering.
